This section contains templates related to processing on the sides of the part:
- The smile handle is parametric - in this template you need to select the side on which the “Smile Handle” will be located, the shape of the handle - Rectangle or Oval. Enter the length, depth, offset from the center of the facade and the rounding radius of the handle. If necessary, you can add an edge to the routing side.
- U-shaped cutout - first you need to select the side on which the U-shaped cutout will be built.
Then:
1) Specify the indent BEFORE the START of the cutout, then the width and depth of the cutout
2) Specify the radii at the entrance and the cutout at the exit
3) Specify the radius of the inner left and right corners
4) If necessary, trim the cutout, indicate the edge
5) And click the "Add" button.
Under all parameters the permissible values are indicated (mm - min/max).
- Outer arc - in this template, first you need to select the side on which the “outer arc” will be built. Then you need to indicate the size in mm to what depth the sides of the arc will be cut. Also, if necessary, indicate the edge for trimming the “Arc” itself
- Internal arc - in this template you need to select the side on which the “Internal Arc” will be built. Then you need to indicate the size (in mm) to what depth the center of the “Arc” will be “recessed”. Also, if necessary, specify the edge for trimming the “Arc” itself.